How It Is Done
A cardiac blood pool scan usually is done in a hospital by a radiology or nuclear medicine technician. Most people do not have to stay overnight in the hospital.
How the test is done is based on the type of scan you are having and the way your hospital does this test.
There are different types of scans. Two of these types are:
- First-pass scan. This scan makes pictures of the blood as it goes through the heart and lungs the first time.
- MUGA scan (multigated acquisition scan). This scan uses the electrical signals of the heart to trigger the camera to take a series of pictures that can be viewed later like a video. The pictures record the heart's motion and check how well it is pumping blood. A MUGA scan may be done before and after your heart is stressed with exercise.
Before the test
You will need to remove any jewelry that might interfere with the scan. You may need to take off all or most of your clothes. You will be given a cloth or paper gown to use during the test.
During the test
You will lie on an examination table beneath the gamma camera. Electrocardiogram (EKG, ECG) electrodes are attached to your chest so that the electrical signal of your heart can also be detected. Then the camera will be positioned close to your body. If you are cold or uncomfortable lying on the table, ask the technician for a pillow or blanket. The camera may be positioned in different places across your chest to record different views of your heart.
The technician cleans the site where the radioactive tracer will be injected. The injection site is typically in the arm, but it may be in the neck. If the arm is used, an elastic band, or tourniquet, is then wrapped around your upper arm to temporarily stop the flow of blood through the veins in your arm. This makes it easier to put the needle into a vein properly. A small amount of the radioactive tracer is then injected, usually into a vein on the inside of your elbow. The radioactive tracer is designed to attach to your blood cells for a short time.
If you are having a multigated acquisition (MUGA) scan, a blood sample may be taken and the tracer added to it, and then it will be reinjected into your vein.
The gamma camera will take pictures as the radioactive tracer moves through your bloodstream and into your heart. It is important not to move while the scan is under way.
The camera does not produce any radiation, so you are not exposed to any additional radiation while the scan is being done. You will need to hold still during each view. You may be asked to:
- Change position for each different view.
- Do some exercise between scans to see how well your heart functions after the stress of exercise.
- Take nitroglycerin to see how well your heart responds to the medicine.
After the test
Once your scan is complete, you usually will be able to leave the testing room right away. You may have to wait at the test center until all of your scan images have been reviewed. If you moved during the scan and the images turned out blurry, the scan may have to be repeated.
Drink lots of water and urinate frequently after your scan to make sure that the tracer flushes completely out of your body. It takes a day or two for the tracer to be completely eliminated.
How long the test takes
How long the test takes depends on the type of scan you are having. Ask your doctor how long your test will take. It could be about 1 hour, or it could take a few hours.