HOW should this medicine be used?
Pilocarpine ophthalmic comes as a 0.4, 1, 1.25, 2, and 4% solution (liquid) to instill in the eyes. For the treatment of glaucoma or ocular hypertension, one drop of the 1, 2, or 4% solution is usually into the affected eye(s) up to four times daily. To prevent or reduce increased pressure in the eye during and after certain types of laser eye surgery, one or two drops of the 1, 2, or 4% solution are usually instilled into the affected eye(s) 15 to 60 minutes before surgery. For the treatment of presbyopia, one drop of the 1.25% solution (Vuity) is usually instilled into the affected eyes once a day or one drop of the 0.4% solution (Qlosi) into the affected eyes up to twice a day (eye drop can be repeated after 2 to 3 hours for an effect of 8 hours) as needed to control symptoms. Follow the directions on your prescription label carefully, and ask your doctor or pharmacist to explain any part you do not understand. Use pilocarpine eye drops exactly as directed. Do not use more or less of it or use it more often than prescribed by your doctor.
Pilocarpine eye drops control your condition, but will not cure it. Continue to use pilocarpine eye drops even if you feel well. Do not stop using pilocarpine eye drops without talking to your doctor.
If you are using another topical eye medication, instill it at least 5 minutes before or after you instill pilocarpine eye drops.
Be careful not to let the tip of the bottle touch your eye, fingers, face, or any surface. If the tip does touch another surface, bacteria may get into the eye drops.
To instill the eye drops, follow these steps:
- Wash your hands thoroughly with soap and water.
- Check the dropper tip to make sure that it is not chipped or cracked.
- Avoid touching the dropper tip against your eye or anything else; eye drops and droppers must be kept clean.
- While tilting your head back, pull down the lower lid of your eye with your index finger to form a pocket.
- Hold the dropper (tip down) with the other hand, as close to the eye as possible without touching it.
- Brace the remaining fingers of that hand against your face.
- While looking up, gently squeeze the dropper so that a single drop falls into the pocket made by the lower eyelid. Remove your index finger from the lower eyelid.
- Close your eye for 2 to 3 minutes and tip your head down as though looking at the floor. Try not to blink or squeeze your eyelids.
- Place a finger on the tear duct and apply gentle pressure for 2 minutes.
- Wipe any excess liquid from your face with a tissue.
- If you are to use more than one drop in the same eye, wait at least 5 minutes before instilling the next drop.
- Replace and tighten the cap on the dropper bottle. Do not wipe or rinse the dropper tip.
- Wash your hands to remove any medication.